How To Adjust The Fabric Movement When Sewing Machine Is Sewing

in use

In the process of sewing materials, irregular movements of clothing and uneven stitches are sometimes observed.

For this kind of breakdown phenomenon, the author analyzes, the cloth material walks all depends on the cloth tooth and the presser foot coordination to forward the pportation, therefore, when the clothing material appears above the irregular movement, we may decide that is the tooth and the presser foot has the breakdown or the pressure adjustment is improper.

If the pressure of the presser foot is too small and the pressure is not tight, it will cause irregular movement.

At this point, we just turn the pressure screw down to compress the material.

In addition, the presser foot is too high.

Presser feet are also unable to press the clothing material, will also cause the material to walk at any time, or does not move at all.

When adjusting, we should first lift the foot wrench, release the guide screw, and move the presser bar up and down. There are many similarities between the sewing machine and the sequins computer embroidery machine.

Sequins computer embroidery machine is an integrated product of machine, electricity and gas. It can automatically switch positions and automatically embroider sequins, sequins and sequins.

After adjusting the distance between the presser foot and the needle plate to the height of 7mm-8mm, tighten the screws immediately and then use it again.

It is worth noticing that there is another reason: because of the loosening of the teeth of the sewing machine, the teeth are swinging around when running, so that the material can not move forward regularly.

In this regard, we suggest that the processing method is: we will unload the needle plate of the sewing machine and tighten the two teeth screws.

After tightening, we can install the needle plate and check the sides of the teeth, whether or not it is friction with the edge of the needle plate groove.

The way of quality arbitration test is the simplest way that most rights holders use most.

about

Quality arbitration is generally recommended for products with clear quality standards and unused and packaged products.

If there is friction, it will cause noise and machine weight. At this time, the needle plate must be unloaded again, the teeth screws should be loosened, the position of the teeth should be adjusted to the middle of the needle slot, and then the needle plate should be tightened after tightening the tooth screws.