Men'S Trousers To Complete The Pattern Drawing Steps

Men's trousers are used for men's trousers.

Based on change.

1. draw the rear pants.

The prototype pattern of the back trousers is marked with the original point 25. Take 25 - D=6cm, point D as the middle point of the rear pocket.

After taking the bag width l4cm, draw the position of the back pocket line.

Add the seam of 5cm on the arc of the trouser leg, cut two pieces and take the warp thread.

2. the front trousers piece draws the prototype pattern of men's trousers and front trousers. On the side seam line, the waist point is marked as point A, take A - B=5cm, take B - C=l9cm as the bag mouth line, connect the point B with the straight line and the side seam trace point C, add the LCM seam on the front oblique pocket line B - C, add the 5cm seam on the trouser leg line.

Cut two pieces, take

。

3. on the basis of the front trousers sheet pattern, the front bag pad is parallel to the B C 5cm of the bag line for D - E, C - F=2.5cm, and the A - D - E - F is used as the front pocket pad (bag lined) pattern.

Cut two pieces and take the warp threads.

4. front pocket welt, on the basis of the front trouser pattern, add the B C parallel to the 5cm, and add the LCM seam on the B C line. Draw B D E F as the front pocket welt pattern.

Cut two slices and take the parallel B - C line as the cloth line.

5. on the basis of the front pants pattern, the front bag bag cloth takes C - G=5cm on the side seam trace, the width of the bag cloth is =17cm, the length of the bag is H - I=32Cm, the curve connects C - I, and the shape of the bag is drawn.

Take H - I as the center line of the bag.

A - C - G and line B - C - G, and LCM joints are added respectively.

Cut two pieces and take the warp threads.

6. the front button (button), the inner button (button), the button inside (mouse tail), on the basis of the front trouser pattern, draw the front arc, take the length =2lcm, the width =5cm, draw the front door pattern with the curve, the same pattern of the inside and the front, and take one piece of cloth warp.

And the pattern in the button is to extend J - K to L, that is, J - K= front arc length +5cm, L - M=4cm, and connect M N with a straight line.

Cut and take 45 of the cloth lines.

7. waist head (

Starting from point O, vertical and horizontal lines are drawn, and the horizontal line is the waist top line.

Take the O - P=4Cm, O - Q=1/2 waistline, draw the horizontal line below the waist head through the dot P, draw the vertical line as the front centerline, point P, P - R=O.5cm, line O O - R as the middle line of the back waist, Q - S=4CM, and - -.

The pattern of R - O - S is drawn on the left waist head (that is, the waist side stitched with the front seam). The pattern of R - O - T is drawn as the right waist head (that is, the waist side stitched with the inside pocket), and LCM joints are added to the edges.

Each piece is cut and weft drawn.

8.. The back pocket and the bag are on the edge of the bag. The width of the welt is +2cm, the width of the bag is about =6cm, and the bag is on the high side.

Cut two pieces and take the warp threads.

9. after bag picking

The width of the cloth is +4cm, the length of the bag is =38cm, and the length of the bag is long.

Cut one piece and take the weft.